One thing that’s quite nice about the new gig is that the office is in Kendall Square. Much, much, much better location-wise than Westford. It means that my commute is just about seven miles which is quite nice to do via bike. Also, if the weather’s bad or I feel lazy, I can take the bus to Alewife from right outside my house and then take the train in.
Unfortunately, I’ve now had two weird pedal failures in the past week. Last Thursday, I was leaving the office and clipped in. As I got about a block away, I noticed my foot moving weirdly on the pedal. As I pulled over to check it out, it became clear that the cleat was stuck in the pedal. After some investigation later, I realized that I lost one of the two screws holding the cleat into the plate in the shoe. It looks like the plate where the screw went in is actually pretty stripped. And in getting the cleat and shoe disengaged from the pedal, I essentially had to take the pedal apart so I decided to switch the pedals out for the plain SPDs instead of the slightly fancier SPDs that were on there.
Today, I was riding home and realized about halfway home that one of the pedals was coming unscrewed from the crank. I made it home without incident and re-installed the pedal without any noticeable problem, but I’m going to be keeping an eye on it over the next few days. Hopefully the crank isn’t stripped — it looked okay, but at this point, I’m a little cautious of it.
Maybe I should look at building a new commuter bike sooner rather than later 🙂 Although I really would like to get the Redline to last another year to year and a half.
Platform pedals are the way forward.
@skvidal Platform pedals wouldn’t have helped with yesterday’s problem. Plus, how am I supposed to bunny hop the monster Cambridge potholes when I’m not clipped in? 🙂
get a bike with a real width tire so you don’t have to bunny hop. You just roll on 🙂
You clearly need some 650x42b 🙂